http://www.comsol.fi/community/forums/general/thread/6878/ Most recent forum messages Sat, 17 Jul 2010 08:51:52 +0000 http://www.comsol.fi/shared/images/logos/comsol_logo.gif http://www.comsol.fi/community/forums/general/thread/6878/ http://www.comsol.fi/community/forums/general/thread/6878/#p19721 can any one please upload their already done RF mems switch design? Sat, 17 Jul 2010 08:51:52 +0000 6878.1279356712.19721 http://www.comsol.fi/community/forums/general/thread/6878/#p18934 can any one please upload their .mph file where if voltage applied, there should be some short circuit and open circuit configuration.<br /> <br /> Thankyou Fri, 09 Jul 2010 05:03:09 +0000 6878.1278651789.18934 http://www.comsol.fi/community/forums/general/thread/6878/#p18458 please help me out in its design.....I am not able to make Short circuit and Open circuit between two conductors --by applying a voltage to the electrode/actuator....<br /> <br /> Thu, 01 Jul 2010 03:36:25 +0000 6878.1277955385.18458 http://www.comsol.fi/community/forums/general/thread/6878/#p18239 HEllo all!!<br /> I am new to COMSOL Multiphysics.I am given a task to design a phase shifter using mems switch.But,i am unable to design a mems switch in comsol.i.e,i am able to draw the Geometry and could not make the cantilever move as i wanted,when a field is applied.Can any one please design a MEMS switch with cantilever(movement at one end-with other end fixed) in comsol and upload the .mph file here....<br /> <br /> Thankyou all...<br /> PLease help me out with this.This is my project.Urgent.... Mon, 28 Jun 2010 23:34:51 +0000 6878.1277768091.18239