Community > Discussion Forum > 3D Swept mesh for Thin domain with ununiform faces

Discussion Forum

3D Swept mesh for Thin domain with ununiform faces

Topics: Mesh, 4.1, 4.2, 4.2a

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   0 Replies   Last post: February 6, 2012 7:48pm UTC
Santhosh Kumar CT

Santhosh Kumar CT

February 6, 2012 7:48pm UTC

3D Swept mesh for Thin domain with ununiform faces

how should i mesh the thin SS layer by swept mesh ... i dont get it at all .. ! even after reading the documentation ... the problem is because of un even faces ..

Attachments:   CM126 half.mph  

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines