Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

defining edges

Please login with a confirmed email address before reporting spam


Hi

in 3D I have a cut plane which cuts a cylinder domain and creates a circular edge.

Is it possible to create a data set of this edge?

otherwise I would need to redefine my domains so that I would get a domain edge in the desired position

as "Data Sets" only accepts domain edges

there must be a less cumbersome way of obtaining the desired data

thanks

David

0 Replies Last Post Jul 13, 2011, 4:59 a.m. EDT
COMSOL Moderator

Hello David Segal

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.